OP-COM opcom 2010V firmware 1.59 installation step-by-step

OP COM USB diagnostic interface for Opel and Vauxhall firmware has newly updated to V1.59. Here is the step-by-step instruction on how to install opcom 1.59 software.

Software version (SW): 08/2010

Firmware version (FW): V1.59

How to install OP-COM 1.59 software?

1)    Install Op-com driver

Open My Computer

Open OP-COM (E:) CD software

Create a new folder “op-com” on Local Disk (C:)

Copy all files in OP-COM CD to the “op-com” folder

Send OP-COM Diagnostic software to Desktop (create shortcut)

Connect China clone OP-COM V1.59 interface with computer via USB port

Wait the system to detect hardware wizard

Select “Install from a list or specific location (Advanced)”, click “Next”

Include and browse location to C:﹨op-com﹨Drivers, click OK

Click “Next”

Click “Next”

Click “Finish” when opcom driver is completely installed

Open My Computer>>Manager>>Device Manager>>Universal Serial Bus controllers>>USB Serial Converter to make sure well communication is built

2) Run Op-com software and diagnose

Plug the op-com cable with vehicle via OBD diagnostic socket

Open “Shortcut to OP-COM” software on desktop

OPCOM CHINA-CLONE 08/2010

Click “Settings”

Click “Test Interface”, you will able to see the OPCOM serial number and firmware version V01.59

Click “Close”

Click “Save Config”

OP-COM Configuration saved! Press “OK”

Back to Opcom software main menu

Select “Diagnostic” function

Select “Automatic Vehicle Identification”

Select “KWP-2000” (K-line) or “CAN” and select diagnostic connector

The op-com 2010V software will display vehicle information, VIN, model, engine code etc

Click “Diagnose ECM” button

Select ECM type and diagnostic connector

Click “Fault Code”

Op-com will display all error codes stored in ECM

The click “Clear Fault Codes” to erase error codes

Perform other diagnostic functions or exit the software program

Unplug the op-com USB interface.